...
Venue Information can be added at a per Access Point level or by editing an AP Group (802.11u Tab). (Make sure the correct operating classes are set for your network configuration)
Ubiquiti Unifi controller (8.4+)
We'll assume you already set up a RADIUS profile for eduroam.
(also see Ubiquiti UniFi OpenRoaming configuration snippet)
Note that Ubiquiti specifies a minimum version of the Network application and AP firmware at their help topic: Setting Up Passpoint on UniFi Network
Access points with firmware versions 6.6.78 or later (most UAP- and U6-Series), or 7.0.66 or later (most U7-Series) will be able to broadcast Passpoint networks.
The controller will warn you after you select Passpoint if you have selected any APs that don't support it.
You can then either try to update them, or limit the Wi-Fi network to access points that have support for Passpoint.
You will not be able to save the Wi-Fi network if you have any APs without Passpoint support selected.
Create a new Wi-Fi network and set the following:
- Name: #Passpoint (this will be the SSID, you can set this to whatever you like)
- Network: The network authenticated users will be connected to, choose your guest network here
- Advanced: Manual
Hotspot 2.0: Passpoint
- Venue Name: See generic Information at the start of this page
- Venue Type: See generic Information at the start of this page
Network Type: Private Network with Guest Access
- IP Address Type Availability: See generic Information at the start of this page
NAI Realm: eduroam.org
Roaming Consortium List
- Name: eduroam
Organization ID: 001BC50460
Operator Friendly Name: Your operator name (1realm)
- Security Protocol: WPA2 Enterprise
- RADIUS Profile: The RADIUS profile for eduroam that you set up earlier
- Other settings you can set as you wish